Simple Question..

Posted by jtatarin on May 05, 2003 at 00:00:42:

I have a few questions about proper heating a ball python. For a hathling BP in a 10 gallon aquarium could I use an UTH by itself without heat lights? Im sorta confused because I have been to TONS AND TONS Of sites and they never give the same temps. I know there has to be a temperature gradient so if I could use an UTH what should the temp be at the spot right above it. Taking note that being the only heat source. I was planning on using a thermostat. Also, would a ceramic heat emitter work. I fear that that would heat the whole enclosure and not give a propper gradient being with only a 10 gallon. So im asking what should the temps be on cool side and warm side. If one side is at 90 degrees I would want the other side considerably cooler right?

Follow Ups:

• Simple Question.. jtatarin 05/05/03 (1)
  • Simple Question.. Krystal19_85 05/05/03 (0)
• Simple Question.. larryskeepers 05/05/03 (0)
• 75-80 cool and about 95 hot bhmorrill 05/05/03 (2)
  • 75-80 cool and about 95 hot jtatarin 05/05/03 (1)
    • 75-80 cool and about 95 hot Mike_S 05/05/03 (0)

---

[ Follow Ups ] [ The Ball Python Forum ]

kingsnake.com | NRAAC.ORG | ReptileBusinessGuide.com | ReptileShowGuide.com | ReptileShows.mobi | Connected By Cars | DesertRunner.org AprilFirstBioEngineering | GunHobbyist.com | GunShowGuide.com | GunShows.mobi | GunBusinessGuide.com | club kingsnake | live stage magazine pool banner - advertise here advertise here advertise here kingsnake.com® is a registered trademark© 1997-     - this site optimized for 1024x768 resolution -