Re: Building a cage

Posted by Ed on March 01, 2002 at 19:26:17:

In Reply to: Re: Building a cage posted by Mike on February 28, 2002 at 18:15:03:

i would suggest going to home depot and investing in some door frames/joints to build the corners. buy some wood, screws, etc. Then you just piece it together and you have a good cage. i would suggest that you build something at least 6'x4'x3'. the bigger the better. it should cost about $300 depending on materials and take about a day for two people to make. I suggest 2x2's and 2x4's for the frame and door and 1/2" harware cloth for three sides with plywood on the floor and back. hope this helps. try this site for tips and ideas.
http://www.cagesbydesign.com/
Good Luck
ED

Follow Ups:

• And don't forget.... Mr. D 03/01/02 (0)

Post a Followup

Name:
E-Mail:

Subject:

Comments:
: i would suggest going to home depot and investing in some door frames/joints to build the corners. buy some wood, screws, etc. Then you just piece it together and you have a good cage. i would suggest that you build something at least 6'x4'x3'. the bigger the better. it should cost about $300 depending on materials and take about a day for two people to make. I suggest 2x2's and 2x4's for the frame and door and 1/2" harware cloth for three sides with plywood on the floor and back. hope this helps. try this site for tips and ideas. : http://www.cagesbydesign.com/ : Good Luck : ED

Optional Link URL:
Link Title:
Optional Image URL:

---

[ Follow Ups ] [ Post Followup ] [ The Iguana Forum ]

kingsnake.com | NRAAC.ORG | ReptileBusinessGuide.com | ReptileShowGuide.com | ReptileShows.mobi | Connected By Cars | DesertRunner.org AprilFirstBioEngineering | GunHobbyist.com | GunShowGuide.com | GunShows.mobi | GunBusinessGuide.com | club kingsnake | live stage magazine pool banner - advertise here advertise here advertise here kingsnake.com® is a registered trademark© 1997-     - this site optimized for 1024x768 resolution -