   |
|
|
|
 Available Now at RodentPro.com! |
News & Events:
|
Posted by snkldy on May 08, 2003 at 19:29:01:
In Reply to: Thanks! Couple more ?s posted by ttreptile1 on May 08, 2003 at 19:12:10:
they make a bit for plastic. and i do lighty sand so the edges are rounded just a little bit. yes it does sound easy but take some scrap and pratice until you think you got it. it took me about 3 hours just to make sure. scrap is cheap
:Thanks Bill! Do you use a special bit on the Rotozip or just the default piece? Do you finish the edges or is the finished product after the zip good enough? Sounds too easy...
::yes it can be done. i do it all the time. i do it with a rotozip and a straight edge clamped to the work. it does leave about 1/8 inch gap but it works well. i just put a stop on the inside so the door dosn't swing in
::you can see the gap in this pic
::hope this helps later bill
:
:
